LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Wiper System & Washer System) >> Repair Instructions >> Washer Pump/Reservoir Replacement (Typical) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Nuts, Bolts and Reservoir
    GM1248438Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the reservoir with the nuts and the bolts.

    Tighten:  Tighten the washer fluid reservoir nuts and bolts to 9 N.m (80 lb in).

  2. Connect the reservoir pump electrical connectors.
  3. Connect the washer hoses to the reservoir.
  4. Install the front wheel well splash shield with the screws.

    Tighten:  Tighten the front wheel well splash shield screws to 1.5 N.m (13 lb in).

  5. Install the front left wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals