LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Wiper System & Washer System) >> Repair Instructions >> Washer Pump Replacement (Typical) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Washer Pump
    GM1248439Courtesy of GENERAL MOTORS CORP.
  1. Install the washer pump.
  2. Connect the washer hose.
  3. Connect the electrical connector.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the front wheel well splash shield with the screws.

    Tighten:  Tighten the front wheel well splash shield screws to 1.5 N.m (13 lb in).

  5. Install the front left wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals