Wipers Blades Do Not Park

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Step	Action	Values	Yes	No
1	Turn the ignition ON. Use a voltmeter to test the battery voltage at the wiper motor. Is battery voltage available at wiper motor connector terminal 3?	11-14 V	Go to Step 3	Go to Step 2
2	Repair the open circuit between the wiper motor and fuse F17. Is the repair complete?	-	System OK	-
3	Turn the ignition ON. Turn the wiper switch to HI. Use a voltmeter to test for a pulse of battery power at the wiper motor when turning the wiper switch OFF. Is a pulse of battery voltage available at the wiper motor connector terminal 2 when the wiper switch is turned OFF?	11-14 V	Go to Step 5	Go to Step 4
4	Replace the wiper motor. Refer to Wiper Motor Replacement . Is the repair complete?	-	System OK	-
5	Turn the ignition ON. Turn the wiper switch to HI. Use a voltmeter to test for a pulse of battery power at the wiper relay when turning the wiper switch OFF. Is a pulse of battery voltage available at the wiper relay connector terminal 31b when the wiper switch is turned OFF?	11-14 V	Go to Step 7	Go to Step 6
6	Repair the open circuit between the wiper motor and the wiper relay. Is the repair complete?	-	System OK	-
7	Disconnect the wiper relay from the connector. Use an ohmmeter to test the continuity of the relay. Is there continuity between wiper relay connector terminals 31b and 53e?	0 Ω	Go to Step 9	Go to Step 8
8	Replace the wiper relay. Is the repair complete?	-	System OK	-
9	Replace the wiper switch. Refer to Wipers/Washer Switch Replacement . Is the repair complete?	-	System OK	-