LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Controls - 1.6L (L91) (Introduction)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Manifold Absolute Pressure Sensor Electrical Connector
    GM1348510Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Remove the manifold absolute pressure (MAP) sensor electrical connector.
  3. Remove the MAP sensor bolt.
  4. Remove the MAP sensor.
scientia non olet · About LEMON Manuals