LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Controls - 1.6L (L91) (Introduction)) >> Repair Instructions >> Knock Sensor (KS) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Knock Sensor
    GM1241935Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the KS with the bolts.

    Tighten:  Tighten the KS bolt to 20 N.m (15 lb ft).

  2. Connect the KS electrical connector.
  3. Install the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical - 1.6L.
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals