LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Controls - 1.6L (L91) (Introduction)) >> Repair Instructions >> Ignition Coil(s) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of EI System Ignition Coil
    GM1289500Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the EI system ignition coil into the mounting location and install the retaining nuts.

    Tighten:  Tighten the EI system ignition coil retaining nuts to 10 N.m (89 lb in).

  2. Connect the EI system ignition coil connector.
  3. Connect the negative battery cable.
scientia non olet · About LEMON Manuals