LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Controls - 1.6L (L91) (Introduction)) >> Repair Instructions >> Exhaust Gas Recirculation (EGR) Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Electrical Exhaust Gas Recirculation Valve
    GM1343726Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the EGR valve with the bolts.

    Tighten:  Tighten the electrical EGR valve retaining bolts to 30 N.m (22 lb ft).

  2. Connect the EGR valve electrical connector.
  3. Connect the negative battery cable.
scientia non olet · About LEMON Manuals