Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Rollover Valve Tube

Courtesy of GENERAL MOTORS CORP.

Install the rollover valve to the fuel tank.
Install the fuel tank. Refer to Fuel Tank Replacement .

Fig 2: View of EVAP Canister Vapor Rear & Purge Tubes

Courtesy of GENERAL MOTORS CORP.

Connect the EVAP canister purge tube.
Install the EVAP canister purge tube clip.
Connect the EVAP canister vapor rear tube.
Install the EVAP canister vapor rear tube clip.

Fig 3: View Of Undercarriage

Courtesy of GENERAL MOTORS CORP.

Install the EVAP canister vapor pipe.
Install the EVAP canister vapor pipe mounting screws and cover.

Fig 4: View Of Pipe Clamps

Courtesy of GENERAL MOTORS CORP.

Install the EVAP canister vapor pipe plastic bolt and cover.
Lower the vehicle.

Fig 5: View of EVAP Canister Pipe & Vapor Rear Tube

Courtesy of GENERAL MOTORS CORP.

Connect the EVAP canister vapor pipe from the EVAP canister vapor rear tube.

Fig 6: View of EVAP Canister Front Tube

Courtesy of GENERAL MOTORS CORP.

Connect the EVAP canister front tube from the EVAP canister purge solenoid valve and the EVAP canister vapor pipe.

Fig 7: View of EVAP Canister Purge Solenoid Valve to Intake Manifold Hose Connection

Courtesy of GENERAL MOTORS CORP.

Connect the EVAP canister purge solenoid valve to intake manifold hose.