LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Controls - 1.6L (L91) (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Canister Flange to Vehicle Bolt
    GM1289477Courtesy of GENERAL MOTORS CORP.
  1. Insert the canister into the track and slide it into position.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Connect the canister fuel vapor hoses.

    Tighten:  Tighten the evaporative emission (EVAP) canister flange bolt to 4 N.m (35 lb in).

  3. Install the canister flange bolt.
scientia non olet · About LEMON Manuals