LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Controls - 1.6L (L91) (Introduction)) >> Repair Instructions >> Engine Coolant Temperature (ECT) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of ECT Sensor Connector
    GM1289410Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the ECT sensor.

    Tighten:  Tighten the ECT sensor to 20 N.m (15 lb ft).

  2. Connect the ECT sensor connector.
  3. Fill the cooling system. Refer to Draining and Filling Cooling System in Engine Cooling.
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals