LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Controls - 1.6L (L91) (Introduction)) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying CKP Sensor Bolt
    GM1289479Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the CKP sensor with the bolt.

    Tighten:  Tighten the CKP sensor bolt to 6.5 N.m (58 lb in).

    2. Fig 2: View of Crankshaft Position Sensor Electrical Connector
    GM1289478Courtesy of GENERAL MOTORS CORP.
  2. Connect the CKP sensor electrical connector.
  3. Connect the negative battery cable.
scientia non olet · About LEMON Manuals