LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Controls - 1.6L (L91) (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Cover Screws
    GM1371851Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Remove the engine cover bolts and the nuts.
  3. Remove the engine cover.
    4. Fig 2: View of Camshaft Position Sensor Electrical Connector
    GM1289481Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the camshaft position (CMP) sensor electrical connector.
  5. Remove the timing belt front cover. Refer to Timing Belt Replacement in Engine Mechanical-1.6L.
scientia non olet · About LEMON Manuals