LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Controls - 1.6L (L91) (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Camshaft Position Sensor Electrical Connector
    GM1289481Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the CMP sensor and bolt.

    Tighten:  Tighten the CMP sensor bolts to 7 N.m (62 lb in).

    2. Fig 2: Identifying Cover Screws
    GM1371851Courtesy of GENERAL MOTORS CORP.
  2. Install the timing bolt front cover. Refer to Timing Belt Replacement in Engine Mechanical-1.6L.
  3. Connect the CMP sensor electrical connector.
  4. Install the engine cover.
  5. Connect the negative battery cable.
scientia non olet · About LEMON Manuals