Removal Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.

NOTE: Refer to Vehicle Lifting and Jacking Notice in Cautions and Notices.

Raise and suitably support the vehicle.
Disconnect the electrical connector for the rear wheel speed sensor from the rear axle.

Fig 1: View of Rear Wheel Speed Sensor
Courtesy of GENERAL MOTORS CORP.
Remove the mounting bolt from the rear wheel speed sensor.
Remove the cable grommets from the rear wheel speed sensor, and remove the speed sensor.