Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Install the rear wheel speed sensor, and install the cable grommets.

Fig 1: Installing Rear Wheel Speed Sensor
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rear wheel sensor mounting bolt.
Tighten: Tighten the bolt to 9 N.m (7 lb ft).
Connect the electrical connector for the rear wheel speed sensor to the rear axle.
Lower the vehicle.
Connect the negative battery cable.