Diagnostic Aids

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

When DTC C0055 is displayed on the scan tool, it should be followed by 2 additional numbers, which should be documented along with any other DTCs that may be displayed.
Repair the low voltage, driveability, or other electrical complaints first, prior to performing DTC C0055.
Ensure the integrity of the connection between the EBCM and the brake pressure modulator valve (BPMV) is secure, tight, and free of corrosion, leaks, and/or damage.

DTC C0055

Step	Action	Yes	No
1	Did you perform the Diagnostic System Check - ABS?	Go to Step 2	Go to Diagnostic System Check - ABS
2	Install the scan tool. Turn ON the ignition, with the engine OFF. Using the scan tool, observe the DTC information. Does the scan tool display any DTCs set in current or history data other than DTC C0055?	Go to Diagnostic Trouble Code (DTC) List	Go to Step 3
3	Turn the ignition switch OFF. Disconnect the harness from the electronic brake control module (EBCM). Check the connectors for damage, corrosion, and terminal contact. Were any problems found?	Go to Step 4	Go to Step 5
4	Repair as needed. Did you find and correct the condition?	System OK	-
5	Replace the EBCM. Refer to Brake Modulator Assembly Replacement (Delphi) or Brake Modulator Assembly Replacement (Mando) . Did you complete the replacement?	System OK	-