LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC 084 >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
DTC 084

Step Action Values Yes No
CAUTION: Refer to SDM Voltage After Ignition Is Turned OFF Caution in Cautions and Notices.
CAUTION: Refer to Sensing and Diagnostic Module Handling Caution in Cautions and Notices.
1 Perform the Diagnostic System Check - SIR.
Is the Diagnostic System Check - SIR complete?		 - Go to Step 2  Go to Diagnostic System Check - SIR 
2
  1. Confirm the ignition switch is OFF.
  2. Wait 1 minute for the sensing and diagnostic module (SDM) charger to be discharged.
  3. Visually inspect any damage for the passenger side air bag sensor wiring and connector.
Is the air bag wiring damaged?		 - Go to Step 3  Go to Step 4 
3 Replace the air bag wiring.
Is the repair complete?		 - Go to Diagnostic System Check - SIR  -
4 Measure the resistance between the SDM and the high, low terminal of the passenger side air bag sensor and the ground.
Is the resistance at the specified value?		 10 K Ω Go to Step 5  Go to Step 3 
5
  1. Replace the SDM.
  2. Reconnect the negative battery cable.
  3. Set the scan tool to CODE ERASE.
  4. Perform the Diagnostic System Check - SIR .
Is DTC 084 still shown as a current fault?		 - Go to Step 6  Go to Diagnostic System Check - SIR 
6 Replace the passenger side air bag sensor.
Is the repair complete?		 - Go to Diagnostic System Check - SIR  -
scientia non olet · About LEMON Manuals