LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC 054 >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
DTC 054

Step Action Values Yes No
CAUTION: Refer to SDM Voltage After Ignition Is Turned OFF Caution in Cautions and Notices.
CAUTION: Refer to Sensing and Diagnostic Module Handling Caution in Cautions and Notices.
1 Perform the Diagnostic System Check - SIR.
Is the Diagnostic System Check - SIR complete?		 - Go to Step 2  Go to Diagnostic System Check - SIR 
2
  1. Confirm the ignition switch is OFF.
  2. Wait for 1 minute for the sensing and diagnostic module (SDM) charger to be discharged.
  3. Visually inspect any damage for the air bag wiring.
Is the air bag wiring damaged?		 - Go to Step 4  Go to Step 3 
3 Measure the resistance between the SDM and the high, low terminal of the driver side air bag module and the ground.
Is the resistance at the specified value?		 10 K Ω Go to Step 5  Go to Step 4 
4 Replace the air bag wiring.
Is the repair complete?		 - Go to Diagnostic System Check - SIR  -
5
  1. Replace the SDM.
  2. Reconnect the negative battery cable.
  3. Set the scan tool to CODE ERASE.
  4. Perform the Diagnostic System Check - SIR .
Is DTC 054 still shown as a current fault?		 - Go to Step 6  Go to Diagnostic System Check - SIR 
6 Replace the driver side air bag module.
Is the repair complete?		 - Go to Diagnostic System Check - SIR  -
scientia non olet · About LEMON Manuals