Conditions for Setting the DTC

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

The resistance of the driver belt pretensioner deploy loop is lower than 1.5 ohms.
The shorting bar is damaged and then the SDM must be replaced.

DTC 010

Step	Action	Values	Yes	No
CAUTION: Refer to SDM Voltage After Ignition Is Turned OFF Caution in Cautions and Notices. CAUTION: Refer to Sensing and Diagnostic Module Handling Caution in Cautions and Notices.
1	Perform the Diagnostic System Check - SIR. Is the Diagnostic System Check - SIR complete?	-	Go to Step 2	Go to Diagnostic System Check - SIR
2	Disconnect the negative battery cable. Connect an ohmmeter to the terminals of the wiring harness connector for the driver seat belt pretensioner module on the sensing and diagnostic module (SDM) side of the connector. Does the ohmmeter show the specified value?	infinity	Go to Step 3	Go to Step 5
3	Replace the SDM. Reconnect the negative battery cable. Set the scan tool to CODE ERASE. Perform the Diagnostic System Check - SIR . Is DTC 010 still shown as a current fault?	-	Go to Step 4	System OK
4	Replace the driver seat belt pretensioner module. Reconnect the negative battery cable. Is the repair complete?	-	Go to Diagnostic System Check - SIR	-
5	Replace the supplemental inflatable restraint (SIR) wiring harness. Reconnect the negative battery cable. Is the repair complete?	-	Go to Diagnostic System Check - SIR	-