LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC 006 >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
DTC 006

Step Action Values Yes No
CAUTION: Refer to SDM Voltage After Ignition Is Turned OFF Caution in Cautions and Notices.
CAUTION: Refer to Sensing and Diagnostic Module Handling Caution in Cautions and Notices.
1 Perform the Diagnostic System Check - SIR.
Is the Diagnostic System Check - SIR complete?		 - Go to Step 2  Go to Diagnostic System Check - SIR 
2
  1. Disconnect the negative battery cable.
  2. Remove the passenger side air bag module.
  3. Connect an ohmmeter to the terminals of the wiring harness connector for the passenger air bag module on the sensing and diagnostic module (SDM) side of the connector.
Does the ohmmeter show the specified value?		 infinity Go to Step 3  Go to Step 5 
3
  1. Replace the SDM.
  2. Install the passenger side air bag module.
  3. Reconnect the negative battery cable.
  4. Set the scan tool to CODE ERASE.
  5. Perform the Diagnostic System Check - SIR .
Is DTC 006 still shown as a current fault?		 - Go to Step 4  System OK
4
  1. Replace the passenger air bag module.
  2. Reconnect the negative battery cable.
Is the repair complete?		 - Go to Diagnostic System Check - SIR  -
5
  1. Replace the supplemental inflatable restraint (SIR) wiring harness.
  2. Reconnect the negative battery cable.
Is the repair complete?		 - Go to Diagnostic System Check - SIR  -
scientia non olet · About LEMON Manuals