LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Body Rear End) >> Repair Instructions >> Fuel Filler Door Release Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Bolt and Handle
    GM1252078Courtesy of GENERAL MOTORS CORP.
  1. Open the luggage compartment.
  2. Remove the left luggage compartment wheelhouse trim panel, both luggage compartment rear quarter trim panels, and the luggage compartment rear trim panel. Refer to Trim Panel Replacement - Cargo Area Rear (Notchback) , Trim Panel Replacement - Cargo Area Rear (Hatchback) , Trim Panel Replacement - Rear Quarter , and Compartment Trim Panel Replacement - Rear in Interior Trim.
  3. Disconnect the cable from the fuel filler door.
  4. Remove the driver front and the rear seats. Refer to Seat Replacement - Front Bucket and Seat Back Replacement - Rear in Seats.
  5. Reposition the floor carpet on the left side of the vehicle.
  6. Remove the bolt and the handle.
    7. Fig 2: View of Cable From Handle
    GM1252079Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the cable from the handle.
  8. Remove the cable.
scientia non olet · About LEMON Manuals