LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Steering Wheel & Steering Column) >> Repair Instructions >> Ignition Lock Cylinder and Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ignition Switch & Retaining Screw
    GM1248388Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the ignition switch with the ignition switch retaining screw.

    Tighten:  Tighten the ignition switch retaining screw to 2 N.m (18 lb in).

  2. Connect the wiring to the ignition switch.
    3. Fig 2: Lower Steering Column Cover Panel & Screws
    GM1248378Courtesy of GENERAL MOTORS CORP.
  3. Install the lock cylinder.
  4. Install the lower steering column cover panel with the screws.

    Tighten:  Tighten the lower steering column cover panel screws to 3 N.m (27 lb in).

  5. Connect the negative battery cable.
scientia non olet · About LEMON Manuals