Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: U-Clamp Bolts & Stabilizer Bar

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the U-clamps and the stabilizer bar to the crossmember.
Tighten: Tighten the U-clamp bolts to the crossmember assembly to 25 N.m (18 lb ft).
Install the crossmember assembly. Refer to Front Suspension Crossmember Replacement .