LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Wiring Systems And Power Management - Connector Identification & Service (1 Of 6)) >> Pull to Seat Connectors >> Terminal Installation

Terminal Installation

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the terminal and pull the wire from the back of the connector in order to seat the terminal.
  2. If necessary, cut the new wire to proper length and splice with existing circuit. Refer to Splicing Copper Wire Using Splice Sleeves .
  3. If the connector is outside of the passenger compartment, apply dielectric grease to the connector.
  4. Install the TPA, CPA and/or the secondary locks.
scientia non olet · About LEMON Manuals