LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Compressor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Compressor A/C Hose Assembly, Connector Block & Fitting Nut
    GM1251945Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution .
  1. Disconnect the negative battery cable.
  2. Discharge and recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  3. Remove the compressor A/C hose assembly connector block fitting nut.
  4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Disconnect the electrical connector at the compressor.
    6. Fig 2: View Of Serpentine Accessory Drive Belt Tensioner
    GM1241549Courtesy of GENERAL MOTORS CORP.
  6. Remove serpentine accessory drive belt.
    7. Fig 3: View Of A/C Compressor
    GM1241695Courtesy of GENERAL MOTORS CORP.
  7. Remove the A/C compressor-to-bracket bolts.
  8. Remove the compressor.
  9. Drain the oil from the compressor into a container. Measure the amount of oil drained and then discard the used oil.
scientia non olet · About LEMON Manuals