Disassembly Procedure
WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
- Remove the compressor. Refer to Compressor Replacement .
- Remove the clutch plate and hub assembly. Refer to Compressor Clutch Plate and Hub Assembly Removal (V5 Compressor) or Compressor Clutch Plate and Hub Assembly Removal (SP10 Compressor) .
- Remove the clutch rotor and bearing. Refer to Clutch Rotor and/or Bearing Removal (V5 Compressor) or Clutch Rotor and/or Bearing Removal (SP10 Compressor) .
- Mark the clutch coil terminal location on the compressor housing.
- Install the J 33023-A (1) on the compressor housing. See Special Tools . Also install the J 8433-1 (3) with the J 33025 (4). See Special Tools .
- Tighten the J 8433-3 (2) against the J 33023-A (1) to remove the clutch coil. See Special Tools .
CAUTION:
Refer to Battery Disconnect Caution
.