LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Front Drive Axle) >> Repair Instructions >> Wheel Drive Shaft Inner Joint and Boot Replacement (Manual) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Small And Large Boot Seals
    GM1242033Courtesy of GENERAL MOTORS CORP.
  1. Remove the large seal retaining clamp. Discard the clamp.
  2. Remove the small seal retaining clamp. Discard the clamp.
    3. Fig 2: View Of Shaft Retaining Ring With J 8059
    GM1242032Courtesy of GENERAL MOTORS CORP.
  3. Degrease the joint.
  4. Remove the shaft retaining ring using the J 8059  (1). See Special Tools .
    5. Fig 3: View Of Axle Shaft And Joint Assembly
    GM1242031Courtesy of GENERAL MOTORS CORP.
  5. Remove the axle shaft from the joint assembly.
    6. CAUTION: The ball retainer is stacked in position and is not servicable. Attempting to service the ball retainer could result in reduced vehicle performance and possible personal injury.
  6. Remove the seal from the joint assembly.
scientia non olet · About LEMON Manuals