LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Pedal Replacement (Hydraulic) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Push Rod & Clutch Pedal
    GM1251785Courtesy of GENERAL MOTORS CORP.
  1. Install the clutch pedal.
  2. Coat the push rod with multi-purpose grease.
  3. Install the push rod to the clutch pedal.
  4. Install the locking clip and push rod fixing pin.
    5. Fig 2: Pedal Mounting Shaft
    GM1251787Courtesy of GENERAL MOTORS CORP.
  5. Coat the pedal mounting shaft with multi-purpose grease.
    6. NOTE: Refer to Fastener Notice .
  6. Install the nut, the washer, and the pedal mounting shaft.

    Tighten:  Tighten the nut to 20 N.m (15 lb ft).

  7. Connect the return spring to the clutch pedal.
  8. Connect the negative battery cable.
scientia non olet · About LEMON Manuals