LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Manual Transaxle - D16) >> Repair Instructions - On Vehicle >> Drive Axle Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Axle Seal Using A Pry Bar
    GM1248180Courtesy of GENERAL MOTORS CORP.
    NOTE: While using a pry bar to remove the axle seal, use extreme care not to damage the bearing adjusting ring on the transmission case.
  1. Remove the drive axle from the transaxle. Refer to Front Drive Axle Inner Shaft Replacement .
  2. Remove the drive axle seal by lifting the outer lip of the seal with a pry bar.
scientia non olet · About LEMON Manuals