LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Manual Transaxle - D16) >> Repair Instructions - Off Vehicle >> Input Shaft Disassemble >> Disassemble

Input Shaft Disassemble: Disassemble

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Detent Screw & Input Driveshaft
    GM1251691Courtesy of GENERAL MOTORS CORP.
  1. Remove the detent screw at the end of the input driveshaft.
    2. Fig 2: Snap Ring & Gear Cluster
    GM1251692Courtesy of GENERAL MOTORS CORP.
  2. Remove the snap ring at the base of the gear cluster.
    3. Fig 3: Input Driveshaft Cluster Gear & J 22912-01
    GM1251693Courtesy of GENERAL MOTORS CORP.
  3. Press the input driveshaft from the input shaft cluster gear using the J 22912-B  (1).
    4. Fig 4: Cluster Shaft Bearing & J 22912-01
    GM1251694Courtesy of GENERAL MOTORS CORP.
  4. Remove the cluster shaft bearing from the input shaft gear cluster using theJ 22912-B  (1).
scientia non olet · About LEMON Manuals