Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Rear Muffler Assembly

Courtesy of GENERAL MOTORS CORP.

Secure the rear muffler assembly to the rubber hangers on the tail pipe end.

NOTE: Refer to Fastener Notice .

Fig 2: View of Rear Muffler Pipe Flange

Courtesy of GENERAL MOTORS CORP.

Secure the nuts and the gasket from the rear muffler pipe flange-to-front muffler pipe flange.
Tighten: Tighten the front muffler-to-rear muffler nuts to 30 N.m (22 lb ft).