LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (Power Steering System) >> Repair Instructions >> Rack and Pinion Outer Tie Rod End Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Outer Tie Rod Hex Nut & Steering Knuckle
    GM1248347Courtesy of GENERAL MOTORS CORP.
  1. Remove the outer tie rod hex nut and disconnect the outer tie rod from the steering knuckle using the KM-507-C  .
    2. Fig 2: Tie Rod Lock Nuts & Outer Tie Rod
    GM1248348Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Before loosening the tie rod lock nut, mark the position of the lock nut for easy alignment after the installation procedure.
  2. Loosen the tie rod lock nuts and remove the outer tie rod.
scientia non olet · About LEMON Manuals