LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Manual Transaxle - Y4M) >> Repair Instructions - Off Vehicle >> Shift Shaft and Fork Assemblies Assemble >> 1st-2nd Gear Shift Shaft Assembly

1st-2nd Gear Shift Shaft Assembly

WARNING: This page is about a different car, the 2008 Pontiac Wave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: 1st-2nd Gear Shift Yoke & Pin
    GM1241246Courtesy of GENERAL MOTORS CORP.
  1. Place the shift shaft into a vise with protector.
  2. Install the 1st-2nd gear shift yoke.
  3. Install the 1st-2nd gear shift yoke pin using a pin (1) punch and a hammer.
  4. Install the 1st-2nd gear shift fork.
  5. Install the 1st-2nd gear fork pin (4) using a pin punch and a hammer.
  6. Install the each shift shaft assembly into the gear unit.
  7. Install the gear unit. Refer to Transmission Assemble .
scientia non olet · About LEMON Manuals