LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Automatic Transaxle - AISIN 81-40LE - DTC P0562 To DTC P0742) >> DTC P0722 (Non European or N. American Emissions) >> Cause of Failure

Cause of Failure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
Step Action Values Yes No
1 Did you perform the Diagnostic System Check - Automatic Transmission? - Go to Step 2  Go to Diagnostic System Check - Automatic Transmission
2
  1. Turn OFF the ignition.
  2. Install the scan tool.
  3. With the engine OFF, turn the ignition switch to the ON position.
  4. Select Store Freeze Frame/Failure Records from the DTC Information menu.
  5. Store Freeze Frame/Failure Records.
  6. Select Clear DTC Information from the DTC Information menu.
  7. Clear the DTC information.
  8. Perform 2 vehicle drive cycles.
Is the hold lamp ON?		 - Go to Step 3  Go to Step 5 
3
  1. Select Request DTC by Status from the DTC Information menu.
  2. Request DTC by Status.
Is DTC P0722 displayed?		 - Go to Step 4  Go to Step 5 
4
  1. Turn OFF the ignition.
  2. Inspect the voltage between vehicle harness and the output shaft speed (OSS) sensor.
  3. Disconnect the transmission control module (TCM) connector of the vehicle harness.
  4. Connect the voltmeter to monitor the voltage between terminal B25 and ground.
  5. Turn ON the ignition and lift up the vehicle.
  6. Measure the voltage change when the wheel is turned slowly.
Is the voltage change within the specified range?		 0-12 V Go to Step 6  Go to Step 7 
5 Repair the temporary connection failure of the connector. Refer to Wiring Harness and Connector Inspection Diagnosis .
Did you complete the repair?		 - System OK -
6
  1. Estimate the failure between the vehicle wiring harness connector and TCM.
  2. Inspect the connector. Refer to Wiring Harness and Connector Inspection Diagnosis .
  3. Inspect the connection condition between the connectors.
Is the connection condition OK?		 - Go to Step 8  Go to Step 5 
7
  1. Estimate the failure of the transaxle harness or between the connectors of the OSS sensor.
  2. Inspect the OSS sensor.
Is the condition of the OSS sensor OK?		 - Go to Step 9  Go to Step 10 
8
  1. Replace the TCM. Refer to Transmission Control Module Replacement .
  2. Perform the reproducing test under user condition after confirming no DTC.
Is DTC displayed?		 - Go to Step 2  System OK
9
  1. Estimate the failure of the transaxle harness.
  2. Test the continuity and short circuit for the T/M wire and inspect the connection condition between connectors C-4. Refer to Wiring Harness and Connector Inspection Diagnosis .
Is the condition OK?		 - System OK Go to Step 5 
10 Replace the OSS. Refer to Output Speed Sensor Replacement .
Is the replacement complete?		 - System OK -
scientia non olet · About LEMON Manuals