LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Automatic Transaxle - AISIN 81-40LE - DTC P0562 To DTC P0742) >> DTC P0717 (Non European or N. American Emissions) >> Cause of Failure

Cause of Failure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
Step Action Values Yes No
1 Did you perform the Diagnostic System Check - Automatic Transmission? - Go to Step 2  Go to Diagnostic System Check - Automatic Transmission
2
  1. Turn OFF the ignition.
  2. Install the scan tool.
  3. With the engine OFF, turn the ignition switch to the ON position.
  4. Select Store Freeze Frame/Failure Records from the DTC Information menu.
  5. Store Freeze Frame/Failure Records.
  6. Select Clear DTC Information from the DTC Information menu.
  7. Clear the DTC Information.
  8. Perform 2 vehicle drive cycles.
Is the hold lamp ON?		 - Go to Step 3  Go to Step 5 
3
  1. Select Request DTC by Status from the DTC information menu.
  2. Request DTC by Status.
Is DTC P0717 displayed?		 - Go to Step 4  Go to Step 5 
4
  1. Turn OFF the ignition.
  2. Measure the resistance between the vehicle harness and the input shaft speed (ISS) sensor. Refer to Input Speed Sensor Inspection .
  3. Disconnect the transmission control module (TCM) connector and measure the resistance between terminal B6 and B16.
Is the measurement within the specified values?		 20°C (68°F)
560-680 Ω		 Go to Step 6  Go to Step 7 
5 Repair the temporary connection failure of the connector. Refer to Connector Repairs .
Did you complete the repair?		 - System OK -
6
  1. Estimate the failure between the vehicle wiring harness connector and the TCM.
  2. Inspect the connector. Refer to Wiring Harness and Connector Inspection Diagnosis .
  3. Inspect the connection condition between the connectors.
Is the connection condition OK?		 - Go to Step 8  Go to Step 5 
7
  1. Estimate the failure of the transaxle harness or between the connectors of the ISS sensor.
  2. Disconnect the ISS sensor connector and inspect the resistance between terminals 1 and 2.
Is the measurement within the specified values?		 20°C (68°F)
560-680 Ω		 Go to Step 9  Go to Step 10 
8
  1. Replace the TCM. Refer to Transmission Control Module Replacement .
  2. Perform the reproducing test under user condition after confirming no DTC.
Is DTC displayed?		 - Go to Step 2  System OK
9
  1. Estimate the failure of the T/M wire.
  2. Test the continuity and short circuit for the transaxle harness and inspect the connection condition between connectors. Refer to Wiring Harness and Connector Inspection Diagnosis .
Is the condition OK?		 - System OK Go to Step 5 
10 Replace the ISS. Refer to Input Speed Sensor Inspection .
Did you complete the replacement?		 - System OK -
scientia non olet · About LEMON Manuals