Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Rear Speakers and Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rear speakers with the screws.
Tighten: Tighten the rear speaker screws to 3 N.m (27 lb in).

Fig 2: View of Rear Window Shelf Trim Panel and Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector.
Install the rear seatback and the rear seat cushion. Refer to Seat Back Replacement - Rear and Seat Cushion Replacement - Rear in Seats.
Connect the negative battery cable.