Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Audio System and Screws

Courtesy of GENERAL MOTORS CORP.

Connect the audio system electrical connector and the antenna cable.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the audio system with the screws.
Tighten: Tighten the audio system screws to 6 N.m (53 lb in).
Install the I/P lower trim panel. Refer to Instrument Panel (I/P) Trim Panel Replacement - Lower in Instrument Panel, Gages, and Console.
Connect the negative battery cable.
Enter the audio security system 4-digit code. Refer to Radio/Audio System Description and Operation .