LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Wheel Drive Shafts >> Repair Instructions >> Wheel Drive Shaft Outer Joint and Seal Replacement (Manual) >> Removal Procedure

Removal Procedure

    Fig 1: View Of Large Seal Retaining Clip And Small Seal Retaining Clamp
    GM1242036Courtesy of GENERAL MOTORS CORP.
  1. Remove the cross groove joint seal assembly. Refer to Wheel Drive Shaft Inner Joint and Seal Replacement (Automatic)  or Wheel Drive Shaft Inner Joint and Seal Replacement (Manual) .
  2. Remove the large seal retaining clip. Discard the clamp.
  3. Remove the small seal retaining clamp. Discard the clamp.
    4. Fig 2: View Of Seal And Joint Assembly
    GM1242035Courtesy of GENERAL MOTORS CORP.
  4. Degrease the joint.
    5. CAUTION: The outer joint is designed to be replaced as a one piece unit. Do not attempt to disassemble or service the outer joint. Improper service will affect both performance of the vehicle and could cause personal injury or vehicle damage.
  5. Remove the seal from the joint assembly.
scientia non olet · About LEMON Manuals