LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Wheel Drive Shafts >> Repair Instructions >> Wheel Drive Shaft Outer Joint and Seal Replacement (Automatic) >> Removal Procedure

Removal Procedure

    Fig 1: View Of Large Seal Retaining Clamp With J 35566
    GM1242025Courtesy of GENERAL MOTORS CORP.
  1. Remove the drive axle from the vehicle. Refer to Inner Shaft and/or Housing Replacement - Front Drive Axle .
  2. Remove the large seal retaining clamp using J 35566  (1). See Special Tools . Discard the clamp.
  3. Remove the small seal retaining clamp. Discard the clamp.
    4. Fig 2: Removing/Installing The Outer Joint And The Axle Shaft Snap Ring
    GM1242026Courtesy of GENERAL MOTORS CORP.
  4. Degrease the joint.
  5. Spread the snap ring using the J 8059  and remove the outer joint and the axle shaft. See Special Tools .
    6. CAUTION: The outer joint is designed to be replaced as a one piece unit. Do not attempt to disassemble or service the outer joint. Improper service will affect both performance of the vehicle and could cause personal injury or vehicle damage.
  6. Remove the seal from the joint assembly.
scientia non olet · About LEMON Manuals