LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Wheel Drive Shafts >> Repair Instructions >> Wheel Drive Shaft Inner Joint and Seal Replacement (Manual) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Axle Shaft And Joint Assembly
    GM1242031Courtesy of GENERAL MOTORS CORP.
  1. Install a new small seal retaining clamp onto the seal. Do not crimp.
  2. Install the seal onto the axle shaft.
  3. Install the joint assembly onto the axle shaft.
    4. Fig 2: View Of Shaft Retaining Ring With J 8059
    GM1242032Courtesy of GENERAL MOTORS CORP.
  4. Install the shaft retaining ring using the J 8059  (1). See Special Tools .
    5. Fig 3: Crimping New Large Seal Retaining Clamp With J 35566
    GM1242038Courtesy of GENERAL MOTORS CORP.
  5. Fill the joint assembly with 120-140 grams (4.2-4.9 ounces) of the recommended grease. Repack the tripot with 120-140 grams (4.2-4.9 ounces) of the recommended grease.
  6. Install the new large seal retaining clamp.
  7. Crimp the new large seal retaining clamp using the J 35566  (1). See Special Tools .
  8. Crimp the new small retaining clamp using the J 35566  (1). See Special Tools .
scientia non olet · About LEMON Manuals