LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Master Cylinder Reservoir Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View of Electrical Connector and Reservoir
    GM1245649Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Remove the reservoir only when replacing a damaged or a leaking reservoir
  1. Disconnect the electrical connector from the reservoir.
    2. Fig 2: Prying Upward To Release Reservoir
    GM1245632Courtesy of GENERAL MOTORS CORP.
  2. For vehicles with the manual transaxle, disconnect the clip to the clutch hose connection at the master cylinder.
  3. Gently pry upward with a screwdriver to release the reservoir.
  4. Tilt the reservoir and pull it upward in order to remove it.
    5. Fig 3: View of Reservoir Seals From Master Cylinder Body
    GM1245634Courtesy of GENERAL MOTORS CORP.
  5. Remove the reservoir seals from the master cylinder body.
scientia non olet · About LEMON Manuals