Installation Procedure

Fig 1: Installing Reservoir On Master Cylinder Body

Courtesy of GENERAL MOTORS CORP.

Lubricate the new seals with clean brake fluid. Install the seals into the cylinder body.
Install the reservoir on the master cylinder body.

Fig 2: Connecting Clip To Clutch Hose Connection At Master Cylinder

Courtesy of GENERAL MOTORS CORP.

For vehicles with the manual transaxle, connect the clip to the clutch hose connection at the master cylinder.

Fig 3: View of Electrical Connector and Reservoir

Courtesy of GENERAL MOTORS CORP.

Add brake fluid.
Raise and suitably support the vehicle.
NOTE: Refer to Vehicle Lifting and Jacking Notice in Cautions and Notices.
Bleed the braking system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
Lower the vehicle.
Connect the reservoir electrical connector.