LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Brake Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View of Stop Lamp Switch, Retaining Ring, Pin, And Pushrod/Brake Pedal Connection Spring
    GM1242053Courtesy of GENERAL MOTORS CORP.
  1. Remove the screws that hold the trim panel to the instrument panel.
  2. Remove the trim panel.
  3. Remove the stop lamp switch. Refer to Stop Lamp Switch Replacement .
  4. Disconnect the retaining ring, the pin, and the spring from the pushrod/brake pedal connection.
    5. Fig 2: Removal Of Brake Pedal
    GM1245628Courtesy of GENERAL MOTORS CORP.
  5. Remove the pedal mounting shaft and nut.
  6. Remove the brake pedal, exposing the brake booster pushrod and the pedal-to-dash panel bracket.
    7. Fig 3: Removal of Brake Pedal Cover
    GM1242052Courtesy of GENERAL MOTORS CORP.
  7. Remove the brake pedal cover.
scientia non olet · About LEMON Manuals