LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Brake Hose Replacement - Rear >> Installation Procedure

Installation Procedure

    Fig 1: View of Brake Lines, Brake Hoses, and Rear Axle Brackets
    GM1242046Courtesy of GENERAL MOTORS CORP.
  1. Install the brake hoses to the body and the rear axle brackets.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Connect the brake lines to the brake hose.

    Tighten:  Tighten the brake lines to 16 N.m (12 lb ft).

    3. Fig 2: View of Brake Hoses
    GM1242047Courtesy of GENERAL MOTORS CORP.
  3. Install the brake hose retainers.
  4. Lower the vehicle.
  5. Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
  6. Check the brake system for leaks.
scientia non olet · About LEMON Manuals