LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Brake Hose Replacement - Front >> Removal Procedure

Removal Procedure

    Fig 1: View of Wheelhousing Bracket Brake Hose and E-Ring Retainer
    GM1242048Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Vehicle Lifting and Jacking Notice in Cautions and Notices.
  1. Raise and support the vehicle.
  2. Disconnect the brake line from the brake hose support bracket on the wheel housing.
  3. Remove the E-ring retainer.
  4. Remove the brake hose from the wheelhousing bracket.
    5. Fig 2: View of Brake Caliper, Seal Rings, and Brake Hose
    GM1242049Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolt from the brake caliper.
  6. Remove the seal rings and the brake hose.
scientia non olet · About LEMON Manuals