LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Brake Hose Replacement - Front >> Installation Procedure

Installation Procedure

    Fig 1: View of Brake Caliper, Seal Rings, and Brake Hose
    GM1242049Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the new brake hose to the caliper with new seal rings and the bolt.

    Tighten:  Tighten the front brake hose-to-caliper bolt to 40 N.m (30 lb ft).

    2. Fig 2: View of Wheelhousing Bracket Brake Hose and E-Ring Retainer
    GM1242048Courtesy of GENERAL MOTORS CORP.
  2. Install the brake hose and the E-ring retainer to the wheelhousing bracket.
  3. Connect the brake line to the brake hose.

    Tighten:  Tighten the brake line to 16 N.m (12 lb ft).

  4. Lower the vehicle.
  5. Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
  6. Check the brake system for leaks.
scientia non olet · About LEMON Manuals