LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Drum Brake System >> Repair Instructions >> Drum Brake Backing Plate Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Nuts Securing Wheel Hub Assembly To Backing Plate
    GM1245739Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Vehicle Lifting and Jacking Notice in Cautions and Notices.
  1. Raise and suitably support the vehicle.
  2. Remove the brake shoe components, including complete removal of the parking brake with the retainer. Refer to Brake Shoe Replacement .
  3. Remove the nuts that secure the wheel hub assembly to the backing plate.
  4. Remove the brake line and plug the opening in the line to prevent fluid loss or contamination.
    5. Fig 2: Wheel Cylinder Assembly
    GM1245741Courtesy of GENERAL MOTORS CORP.
  5. Remove the wheel cylinder assembly. Refer to Wheel Cylinder Replacement .
  6. Remove the wheel hub assembly.
  7. In case of an antilock brake system (ABS) brake, disconnect the cable that goes to the wheel speed sensor.
  8. Separate the backing plate and the gasket.
scientia non olet · About LEMON Manuals