LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Drum Brake System >> Repair Instructions >> Brake Shoe Inspection >> Inspection Procedure

Inspection Procedure

  1. Remove the brake drum. Refer to Brake Drum Replacement .
    2. CAUTION: Refer to Brake Dust Caution in Cautions and Notices.
    Fig 1: Measuring Lining Thickness
    GM1241952Courtesy of GENERAL MOTORS CORP.
  2. Measure the lining thickness.

    Specification:  The minimum lining thickness is 0.5 mm (0.02 in).

    3. IMPORTANT: Replace the shoe and lining assembly in axle sets only.
  3. If the lining thickness is less than the specification, or if a defect is found, replace the linings. Refer to Brake Shoe Replacement .
  4. Install the brake drum. Refer to Brake Drum Replacement .
scientia non olet · About LEMON Manuals