LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Drum Brake System >> Repair Instructions >> Brake Drum Replacement >> Installation Procedure

Installation Procedure

  1. Adjust the rear brakes. Refer to Drum Brake Adjustment .
    2. Fig 1: View of Drum From Spindle
    GM1242004Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Slide the brake drum straight on the spindle. Use care in order to properly position the wheel bearings and the drum on the spindle.
  2. Install the brake drum to the spindle.
    3. Fig 2: View of Lock Ring and Caulking Nut From Spindle
    GM1245719Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the lock ring and the caulking nut to the spindle.

    Tighten:  Tighten the nut to 200 N.m (148 lb ft).

  4. Stake the lock ring to the nut.
  5. Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
    7. IMPORTANT: If the clicking sound of the adjuster is not audible from either brake drum, the clearance between the brake shoes and the brake drum is adjusted.
  7. Apply the brake pedal at least 10 times.

    Verify the clicking sound of the adjuster assembly is not audible from either brake drum.

  8. Adjust the park brake. Refer to Park Brake Adjustment .
scientia non olet · About LEMON Manuals