LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumper System >> Repair Instructions >> Fascia Replacement - Front Bumper >> Removal Procedure

Removal Procedure

    Fig 1: View of Screws, Bolts, Nuts, and Front Wheel Well Splash Shields
    GM1248501Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable.
  2. Remove the front wheels.

    Refer to Tire and Wheel Removal and Installation in Tires and Wheels.

  3. Remove the screws, the bolts, the nuts, and the front wheel well splash shields.
    4. Fig 2: View of Screws Underneath Fascia
    GM1248502Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  4. Remove the headlamps, the turn signal lamps, the side turn signal lamps and the front fog lamps.

    Refer to Headlamp Replacement (Hatchback) or Headlamp Replacement (Notchback) , Turn Signal Lamp Replacement (Hatchback) or Turn Signal Lamp Replacement (Notchback) and Fog Lamp Replacement - Front in Lighting Systems.

  5. Remove the screws from the wheel wells.
  6. Remove the nuts from the fascia.
  7. Remove the screws from underneath the fascia.
    8. Fig 3: View of Front Bumper Fascia
    GM1248503Courtesy of GENERAL MOTORS CORP.
  8. Remove the screws on the top of the fascia.
  9. Remove the front bumper fascia.
scientia non olet · About LEMON Manuals